- Main mount (you bolt it on the printer carrier) 3 types of main
mount , side probe position (left and right) front probe position (left
or right) and no probe at all. Here is the main mount, right hand "Z" axis probe positioning; at 90 degrees.
To be
bolted on the machine carier you have, once and for good, depending on your
machine you will have to figure out alone what you need in therms of nuts and bolts and how to do
it (might imply some drilling and threading in the carrier or in the main mount 3D printed part).
For
the price you have one main mount, left hand "Z" axis probe
positioning; at 90 degrees. You need to buy the M4 or M3 nuts and
bolts.
Word of advice from experience, PLA will fail in time due
to proximity of hot elements like heated bed or the hotend, but can
print in an open printer frame over 100 hours before it fails sometimes.
If
you intend to run your printer on the hot side of polymers do not go
for PLA, rather nylon, or PPS or similar, if you intend to go fully
enclosed and really hot polymers in printing, I reccomend you go PEI or
PEKK.
Flip main mount, right hand "Z" axis probe positioning; at 90 degrees, 3D printed
- Brand: Maker
- Product Code: Flip main mount, right hand "Z" axis; at 90 degrees
- Availability: In Stock
-
£9.20
- Ex Tax: £6.00
Available Options
Related Products
Flip, calibration mount tool, 3D printed.
- Fitting die calibration tool, this is like a main mount plus a lower flat surface so all your printing head mounts fit exactly in position, than you place the heatsink with heatbreak and nozzle on it and mark for the holes thus making shure your tool is on the exact height when changed on ..
£9.20 Ex Tax: £6.00
FLIP - Z height probe mount, can fit most probes, 3D printed
Z height probe mount (you slide up and down the main mount with a screw to adjust) for most probe.It is a Z axis sensor slider support adjustable as needed to the micron of height by twisting a screw... Bye bye sensor adjusting headache. For the price you have one Z height probe mount,..
£6.80 Ex Tax: £4.00
FLIP, V6 (or5) heatsink holder, 3D printed
V6 (or5) holder and the neck counter piece. To fit this you need 1 of M3 bolt long 15 mm and 2 M3 bolts long as per your measurment plus 2 nylock nuts. You also need washers, a 2mm drill bit to drill the main adapter at the corresponding hole in the piece holder, and an M3 tap to tap said ho..
£9.20 Ex Tax: £6.00
FLIP Universal Extended Tools Holder, 3D printed on demand
Extended Universal Tools Holder, you can buy as many of them as you need, depending on how many different hotends you have to swap. It can mount Chimera, Water cooled heatsinks, and many other models.It is longer than the regular Universal Tools Holder, just in case you need to fit som..
£8.00 Ex Tax: £5.00
Tags: Flip, tool swap, assembly for cheap 3D printers, STL files, printable files, main mount