This jar is suitable mainly for for router bits, beveling tools, etc.

For the price you have one jar diameter 80mm height 25mm aproximativelly.

Word of advice from experience, PLA will fail in time due to proximity of hot elements like hotends, heated beds, stoves, heaters, hot tools (like soldering irons).

If you intend to use your jar by the hot side or to hold hot tools do not go for PLA, rather nylon, or PPS or similar, if you intend to go really hot I reccomend you go PEI or GF 30PP.

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Enter the code in the box below

Tools holding jar 80mm O.D. 25mm Height, 8mm honeycomb spacing. 3D printed on demand

Brand: Maker
Product Code: Tools holding jar 80mm O.D. 25mm Height, 8mm honeycomb spacing
Availability: In Stock

£8.00
Ex Tax: £5.00

Available Options

Polymer used

GF30-PP: (30% fibreglass) tough, flexible, watertight, brittle. Resistant to solvent, adhesives. Glass transition 200C. (+£6.00)

HTPET+ is a PETE polymer, the same plastic used to make soda pop bottles. It has a glass transition temperature of 82c. (+£2.40)

PEI 9085: Polyethylenimine glass transition 220C, extremely mechanically resistant, low chemically resistance (+£12.00)

PLA natural (translucent)

Nylon (PolyAmide), elastic, resistant mechanically and to domestic solvents, glass transition 150C natural (translucent) (+£3.60)

Carbon fiber PLA black matt, enhances the mecanicall rigidity but becomes more brittle, glass transition 60C (+£1.20)

Carbon fiber Nylon (CF PA), enhanced rigidity, and mechancicall risitance, glass transition 160C black matt (+£4.80)

PPS Polyphenilene sulphide extremely chemically resistantto acetone, and many other solvents; natural (translucent) (+£8.40)

Qty

0 reviews / Write a review